Removing The Blank Cover From The Rear Panel; Installing Or Replacing The Rtm Isdn Card; Removing The Blank Cover; Removing An Existing Rtm Isdn Card - Polycom 2000 Hardware Manual

RealPresence®Collaboration Server (RMX) 2000 Hardware Guide

Removing the Blank Cover from the Rear Panel

Use the following procedure to remove the blank cover.
To remove the blank cover from a rear panel:
1 Ensure that the power switch/circuit switch on the RMX is turned OFF (O).
2 Unscrew the captive screws on the rear panel of the RMX that secure the blank panel.
3 Use the metal ejector levers to pull the blank panel.

Installing or Replacing the RTM ISDN Card

As a first installation, the RTM ISDN card must be installed in the top slot of the RMX chassis. The RTM
ISDN card must be seated opposite to an MPMx/MPMRx card located in the top slot on the front of the RMX.
Prior to adding the RTM ISDN card you must have your ISDN product license available. For more
information see, RealPresence Collaboration Server 1500/1800/2000/4000 Getting Started Guide,
Procedure 2: Product Registration

Removing the Blank Cover

For details, see Removing the Blank Cover from the Rear Panel

Removing an Existing RTM ISDN Card

To remove an existing RTM ISDN card:
1 Ensure that the power switch on the RMX 2000 is turned OFF (O).
2 Unscrew the captive screws that fasten the card to the MCU. Use the metal ejector levers to pull the
card out of its slot from the backplane.
3 Slide out the RTM ISDN card.
Polycom, Inc.
.
48