Replacing An Ac Power Entry Module (Pem) - Polycom 4000 Hardware Manual

RealPresence®Collaboration Server 4000 Hardware Guide
2 Using your right hand, press your thumb on the pressure latch and with your fingers inserted in the
hand grip (on top), pull the Power Supply unit out.
3 Carefully slide the Power Supply unit out from the front slot.
4 Slide in the replacement Power Supply unit.
5 Push the Power Supply unit firmly into the Backplane, making sure it is properly seated in its slot,
and that the latch is in a locked position.
6 Tighten the captive screws on the front panel of the Power Supply unit to the chassis.

Replacing an AC Power Entry Module (PEM)

On the rear of the RMX three AC PEM's are fitted, each with their own power cord.
Use the following procedure to replace a Power Entry Module (PEM).
Please verify the type of PEM used on your RMX 4000. Do not insert a PEM of a different type on
your system.
Polycom, Inc. 58