Table of Contents
Advertisement
Polycom RMX 2000 Hardware Guide
Replacing a RTM ISDN Card
The blue HS LEDs on the MPM/MPM+/MPMx card and the Control
Unit start flashing and the power on cycle for the card is initiated:
— The card's resources are added to the system resources list
— The number of available ports on the RMX is increased to the
current CFS license level
— Port usage is re-calculated and the Port Gauges and Video/Voice
Port Configuration are updated
When the power on cycle of the MPM/MPM+/MPMx card is
completed, the blue HS LEDs will turn OFF. The green RDY LED on
the MPM/MPM+/MPMx card switches on and remains lit.
The RTM ISDN card can only be used with software version 3.0 or higher.
1
Ensure that the power switch on the RMX 2000 is turned OFF (O).
2
Loosen the captive screws that fasten the card to the MCU.
3
Remove the RTM ISDN card. Use the metal ejector levers to pull the
RTM ISDN card out of its slot in the backplane.
4
Carefully slide the RTM ISDN card out through the front panel.
5
On the card to be installed, move the ejector levers to their fully open
position.
Ejector Lever
Captive Screw
1-37
Advertisement
Table of Contents
