Replacing An Ac Power Supply Module - Polycom 4000 Hardware Manual

RealPresence®Collaboration Server 4000 Hardware Guide
2 Unscrew the captive screws on the front panel of the CNTL 4000 Module that secure the
the chassis.
3 Use the metal ejector lever to pull the CNTL 4000 Module out of its slot in the Backplane.
4 Carefully slide the CNTL 4000 Module out through the front panel.
5 On the CNTL 4000 Module to be installed, move the ejector lever to the fully open position.
6 Slide in the replacement CNTL 4000 Module.
7 Push the CNTL 4000 Module firmly into the Backplane, making sure it is properly seated in its slot.
8 Ensure that the metal ejector lever is fully retracted into it's housing.
9 Tighten the captive screws on the front panel of the CNTL
Module to the chassis.
10 Turn ON the RMX 4000.

Replacing an AC Power Supply Module

Two units supply power to the RMX 4000 (3rd optional - AC only), each unit with its own power cord. Use
the following procedure to replace a Power Supply unit.
Please verify the type of power supply used on your RMX 4000. Do not insert a different type of
power supply than the current type installed on your system.
To replace an AC power supply module:
1 Unscrew the captive screws on the front panel of the Power Supply unit that secures the unit to the
chassis.
Polycom, Inc.
4000
Module that secure the CNTL 4000
m
odule to
57