Removing And Replacing The Main Battery - Agilent Technologies FieldFox N9923AN Service Manual

RF Vector Network Analyzer
N9923AN

Removing and Replacing the Main Battery

Tools Required
• None
Refer to
IMPORTANT
disposing of the old battery.
Replacing the Main Battery
1. Disconnect the power cord.
2. Remove the battery compartment door by pushing in on the detent and then sliding the
door downwards.
3. Note the orientation of the battery for installation of the replacement.
4. Remove the old battery and install the new battery in the battery compartment.
5. Reinstall the battery compartment door by aligning it in position and then sliding it
upwards until an audible click is heard.
Figure 7-1 Replacing the Main Battery
Service Guide N9923-90005
"Battery Disposal" on page 1-7
Repair and Replacement Procedures
Removing and Replacing the Main Battery
for important instructions on
7-5