Raising And Removing The Receiver Deck - Agilent Technologies PNA Series Service Manual

Repair and Replacement Procedures

Raising and Removing the Receiver Deck

Raising and Removing the Receiver Deck
Tools Required
• T-10 TORX driver (set to 9 in-lb)
Raising the Receiver Deck
Refer to Figure 7-2 for this procedure.
1. Disconnect the power cord.
2. Remove the outer cover.
3. Place the analyzer bottom-side up on a flat surface.
4. With a T-10 TORX driver, remove the four screws (item
5. Pull the latch pin (item
6. Lift the receiver deck to partially raise it, then release the latch pin (item
receiver deck to its fully raised position and ensure that the latch pin latches in the
raised position.
Lowering the Receiver Deck
Refer to Figure 7-2 for this procedure.
1. Pull the latch pin (item
deck.
2. Lift the receiver deck to partially lower it, then release the latch pin (item
the receiver deck to its fully lowered position and ensure that the latch pin latches in
the lowered position.
3. With a T-10 TORX driver, install the four screws (item
Removing the Receiver Deck
Refer to Figure 7-2 for this procedure.
1. Raise the receiver deck as outlined in
2. Disconnect the flexible cables (item
cables and connectors for proper reconnection later.
3. Pull the latch pin (item
4. Lift the side of the receiver deck that was just released, above the side of the analyzer,
and then lift the entire receiver deck out of the analyzer.
Replacing the Receiver Deck
Refer to Figure 7-2 for this procedure.
1. Reverse the procedure for
7-8
②
) toward the center of the analyzer to release receiver deck.
②
) toward the center of the analyzer to release the receiver
"Raising the Receiver Deck,"
③
) and the two ribbon cables (item
⑤
) to release one side of the receiver deck.
"Removing the Receiver Deck,"
PNA Series Microwave Network Analyzers
①
), securing the receiver deck.
②
②
①
), to secure the receiver deck.
above.
④
). Label the
above.
Service Guide E8361-90001
E8361A
). Lift the
). Lower