Raising And Removing The Receiver Deck - Agilent Technologies E8362A Service Manual

Repair and Replacement Procedures

Raising and Removing the Receiver Deck

Raising and Removing the Receiver Deck
Tools Required
• T-10 TORX driver (set to 9 in-lb)
Raising the Receiver Deck
Refer to Figure 7-2 for this procedure.
1. Disconnect the power cord.
2. Remove the outer cover. Refer to
3. Place the analyzer bottom-side up on a flat surface.
4. With a T-10 TORX driver, remove the four screws (item
deck.
5. Pull the latch pin (item
deck.
6. Lift the receiver deck to partially raise it, then release the latch pin (item
receiver deck to its fully raised position and ensure that the latch pin latches in the
raised position.
Lowering the Receiver Deck
Refer to Figure 7-2 for this procedure.
1. Pull the latch pin (item
deck.
2. Lift the receiver deck to partially lower it, then release the latch pin (item
the receiver deck to its fully lowered position and ensure that the latch pin latches in
the lowered position.
3. With a T-10 TORX driver, install the four screws (item
Removing the Receiver Deck
Refer to Figure 7-2 for this procedure.
1. Raise the receiver deck as outlined in
2. Disconnect the ten flexible cables (item
3. Pull the latch pin (item
4. Lift the side of the receiver deck that was just released, above the side of the analyzer,
and then lift the entire receiver deck out of the analyzer.
Replacing the Receiver Deck
Refer to Figure 7-2 for this procedure.
1. Reverse the procedure for
7-8
"Removing the Covers" on page
②
) towards the center of the analyzer to release the receiver
②
) toward the center of the analyzer to release the receiver
"Raising the Receiver Deck,"
③
), and the ribbon cable (item
⑤
) to release one side of the receiver deck.
"Removing the Receiver Deck,"
PNA Series Microwave Network Analyzers
E8362A, E8363A, E8364A
7-6.
①
), that secure the receiver
②
②
①
), to secure the receiver deck.
above.
④
).
above.
Service Guide E8364-90001
). Lift the
). Lower