Intel EtherExpress PRO/100 User Manual page 91

Troubleshooting
Please specify a non-zero decimal number for the SOCKET keyword
This message applies to both the ODI and NDIS 2.0 drivers. The value
specified under the SOCKET keyword in the NET.CFG or
PROTOCOL.INI file must be a decimal number other than zero.
Please specify either 8 or 16 for the WORDSIZE keyword
This message applies to both the ODI and NDIS 2.0 drivers. The value
specified under the WORDSIZE keyword in the NET.CFG or
PROTOCOL.INI file must be either 8 or 16.
Please specify either IO or MEM for the MODE keyword
This message applies to both the ODI and NDIS 2.0 drivers. The value
specified under the MODE keyword in the NET.CFG or
PROTOCOL.INI file must be either IO or MEM.
The card is unreadable, possible memory conflict
The Card Information Structure (CIS) of the PC Card was unreadable.
This could be a result of failure to exclude the selected memory range
from the memory managers loaded on the machine. Either exclude a
4K memory range, or select a memory range that has already been
excluded.
The I/O test failed - Please select a different I/O address
The driver failed the I/O test. Try a different I/O address.
The IRQ test failed - Please select a different IRQ
The driver failed the IRQ test. Try a different IRQ address.
The memory test failed - Please select a different memory address
The memory test will write data into the memory, read them back, and
verify if they are the same. In this case, the memory written and read
back were found to be different.
The Network Controller is not responding
A Intel PRO/100 PC Card adapter was detected, but subsequent
attempts to initialize the network controller failed. Try setting the
WORDSIZE parameter to 8.
The Intel PRO/100 PC Card has not been initialized
91