Intel EtherExpress PRO/100 User Manual page 31

6 (This step is not required for PC/TCP versions 2.10 and later.)
Using a text editor, add the following lines to your CONFIG.SYS
file:
DEVICE=[ path ]IPCUST.SYS
DEVICE=[ path ]IFCUST.SYS
where [path] is the drive and directory specified at the PC/TCP
installation.
7 Reboot the PC.
8 Change to the directory where your PC/TCP files are stored and
run INTELPD.BAT by typing:
INTELPD
9 Run the ETHDRV.EXE kernel program supplied with PC/TCP.
This loads the PC/TCP kernel into memory. The packet driver
must always load before the kernel.
10 Continue your server or workstation startup as instructed in the
PC/TCP documentation.
ODI with FTP Software PC/TCP and NetWare
If you need to run Novell NetWare concurrently with FTP PC/TCP,
proceed as follows:
1 Run the Intel Installation Program from Disk 1, Installation Disk.
2 Choose FTP PC/TCP from the Select Network Operating System
screen.
3 Follow the prompts to complete the Intel segment of the
installation.
4 Install PC/TCP according to the instructions in your FTP PC/TCP
manual.
5 (This step is not required for PC/TCP versions 2.10 and later.)
Using a text editor, add the following lines to your CONFIG.SYS
file:
DEVICE=[ path ]IPCUST.SYS
DEVICE=[ path ]IFCUST.SYS
where [path] is the drive and directory specified in the PC/TCP
installation.
Software Installation
31