Intel EtherExpress PRO/100 User Manual page 15

of a NetWare Client, proceed to the heading Verification of
NetWare Client Configuration.
• An X or a circled exclamation point on top of the PRO/100
Mobile Adapter 16 icon indicates a problem. Select PRO/100
Mobile Adapter 16 and click Properties to see an explanation.
Then continue with step 2 below.
2 To review the installed Adapter configuration, double-click the
Network icon in the Control Panel.
3 Select the PRO/100 Mobile Adapter 16 component and click
Properties.
4 From the Properties window, select the Advanced tab.
5 Confirm that the Properties and their associated Values are
correct and that there are no conflicts with other installed
devices. (For a technical discussion of these settings, see
Chapter 3, Configuration Reference in this User's Guide. For
more detailed troubleshooting information, see Chapter 4,
Troubleshooting.)
Verification of NetWare Client Configuration
1 After installing the PRO/100 Mobile PC Card driver and
verifying the installation as described above, check for configu-
ration of the NetWare Client by clicking on the Network icon.
You should see both "Client for Microsoft" and "Client for
Novell" listed. The installation process includes configuration
for a NetWare Client as a default. If "Client for Novell" does not
appear, you can configure the NetWare Client with the follow-
ing steps:
2 In the Control Panel, double-click the Network icon.
3 From the Configuration tab in the Network window, click Add.
4 From the Select Network Component Type window, select
Client and click Add.
5 Under Manufacturers in the Select Network Client window,
select Microsoft.
6 In the Network Clients window, select Client for NetWare
Networks.
7 Click OK (you will be returned to the Network window).
Software Installation
15