Dec Pathworks Versions 5.X Or 6.X - Intel EtherExpress PRO/100 User Manual

DEC PATHWORKS versions 5.x or 6.x

NDIS 2.0 Driver
These instructions are based on PATHWORKS documentation for
configuration of a PC as a client workstation, using a system service
already installed on a LAN Manager server and the LAN Manager
SETUP diskette.
1 Run the Intel Installation Program from Disk 1, Installation Disk.
2 Choose DEC PATHWORKS from the Select Network Operating
System screen.
3 Follow the prompts to complete the Intel segment of the
installation. Note the IRQ value set by the Intel Installation
Program for use in steps 5 and 23 below.
4 Check the README file on your PATHWORKS SETUP disk for
requirements such as lastdrive, setver, etc. You will need 500 K of
free conventional memory and about 1 MB of extended memory
to run PATHWORKS SETUP. Be sure you have a lastdrive
statement in your CONFIG.SYS file (lastdrive=g will work in
most cases).
5 Use a text editor to modify the file A:\NDIS\PI.TPL on the
PATHWORKS SETUP disk, as follows (A:\NDIS is a hidden
directory. You can access it by typing CD A:\NDIS):
Change the line (remove the semicolon)
;NI_IRQ = (irq value from step 3)
to read
NI_IRQ = (irq value from step 3)
The NI_IRQ value must be the same as the interrupt value you
will use for the Intel adapter.
Software Installation
23