Intel EtherExpress PRO/100 User Manual page 35

7 Answer [Y]es to use of programs needing the NETBIOS
interface.
8 When prompted, select the Etherand Network family of network
cards.
9 Continue with the installation until finished.
10 Use a text editor to replace the line in your CONFIG.SYS file that
reads:
device=\XX.DOS
with the two lines
device=\M16ACFG.EXE DRIVER=NDIS
device=\M16ANDIS.EXE
11 Still in the CONFIG.SYS file, add the parameter O=N (where O
is a letter, not zero) to the line
device=\DXMT0MOD.SYS
as follows
device=\DXMT0MOD.SYS O=N
12 Copy the files M16ACFG.EXE and M16ANDIS.EXE from the
directory C:\INTEL\M16A to the root directory of your hard disk
or boot disk.
13 Change to the LANMAN directory on your hard disk or boot disk.
14 Use a text editor to modify the PROTOCOL.INI file in the
C:\LSP directory as follows:
• Under the ETHERAND section, change the line that reads
Bindings = TCMAC2
to:
Bindings = INTELNET
• Underneath that section insert a new section that reads as
follows:
[INTELNET]
DriverName = INTEL$
15 Use a text editor to edit the keyword settings in the
PROTOCOL.INI file in the C:\LSP directory to match the
keywords contained in the sample PROTOCOL.INI file located at
C:\INTEL\M16A as required (unless you are using Intel PRO/100
PC Card default settings).
16 Save the file and reboot the PC.
Software Installation
35