Intel EtherExpress PRO/100 User Manual page 29

12 Change to the C:\ (root) directory.
13 Use a text editor to modify the AUTOEXEC.BAT file as follows
(\PCTCP is the default installation directory):
• Move the line containing the STARTNET.BAT command or
the lines containing the network driver files to immediately
above the line
SET PCTCP=C:\PCTCP\PCTCP.INI
• Add the line
C:\PCTCP\ODIPKT
after the line
PCTCP=C:\PCTCP\PCTCP.INI
14 Save the file and exit the text editor.
15 Copy the file ODIPKT from disk 5 of the FTP PC/TCP
installation disks to the directory into which PC/TCP was
installed.
16 Reboot the PC.
FTP PC/TCP 3.X with OnNet 1.1 with Windows 3.1
1 Run the Intel Installation Program from Disk 1, Installation Disk.
2 From the Select Network Operating System screen, choose FTP
PC/TCP.
3 Follow the prompts to complete the Intel installation.
4 Run the PC/TCP installation program OnNet 1.1.
5 When prompted, insert the Intel Network Drivers Disk (Disk 2).
6 Follow prompts to complete the PC/TCP installation.
7a For an NDIS installation, reboot the PC.
7b For ODI installation, do not reboot. Continue with step 8.
Additional Steps for ODI Installation
If you are using an ODI driver, continue with the following steps:
8 Change to the directory into which PC/TCP was installed.
9 Use a text editor to change the file PCTCP.INI as follows:
• In the section PCTCP ifcust 0 change the line
interface-type=NDIS
Software Installation
29