Displaying Poe Profile Configuration; Poe Profile Configuration Example; Poe Profile Application Example - H3C S5100-SI Operation Manual

Note the following during the configuration:
1) When the apply poe-profile command is used to apply a PoE profile to a port, some PoE
features in the PoE profile can be applied successfully while some cannot. PoE profiles are
applied to S5100-SI/EI series Ethernet switches according to the following rules:
When the apply poe-profile command is used to apply a PoE profile to a port, the PoE profile is
applied successfully only if one PoE feature in the PoE profile is applied properly. When the
display current-configuration command is used for query, it is displayed that the PoE profile is
applied properly to the port.
If one or more features in the PoE profile are not applied properly on a port, the switch will prompt
explicitly which PoE features in the PoE profile are not applied properly on which ports.
The display current-configuration command can be used to query which PoE profile is applied to
a port. However, the command cannot be used to query which PoE features in a PoE profiles are
applied successfully.

Displaying PoE Profile Configuration

After the above configuration, execute the display command in any view to see the running status of
the PoE profile and verify the effect of the configuration by checking the displayed information.
Table 2-2 Display the PoE profile configuration
Operation
Display the detailed
information about the PoE
profiles created on the switch

PoE Profile Configuration Example

PoE Profile Application Example

Network requirements
Switch A is an S5100-SI/EI series Ethernet switch supporting PoE.
GigabitEthernet 1/0/1 through GigabitEthernet 1/0/10 of Switch A are used by users of group A, who
have the following requirements:
The PoE function can be enabled on all ports in use.
Signal mode is used to supply power.
The PoE priority for GigabitEthernet 1/0/1 through GigabitEthernet 1/0/5 is Critical, whereas the
PoE priority for GigabitEthernet 1/0/6 through GigabitEthernet 1/0/10 is High.
Operation
Enter
Ethernet
port view
In
Ethernet
Apply the
port view
existing PoE
profile to the
port
display poe-profile { all-profile |
interface interface-type
interface-number | name profile-name }
Command
interface interface-type
interface-number
apply poe-profile
profile-name
Command
2-2
Description
Description
Available in any view