Vlan Mapping Configuration Example - H3C S5100-SI Operation Manual

[Sysname] interface GigabitEthernet 1/0/2
[Sysname-GigabitEthernet1/0/2] traffic-priority inbound ip-group 3000 rule 0 cos
4
[Sysname-GigabitEthernet1/0/2] traffic-priority inbound ip-group 3000 rule 1 cos
3
[Sysname-GigabitEthernet1/0/2] traffic-priority inbound ip-group 3000 rule 2 cos
2
[Sysname-GigabitEthernet1/0/2] quit
3) Configure queue scheduling
# Apply SP queuing.
[Sysname] undo queue-scheduler

VLAN Mapping Configuration Example

Network requirements
As shown in
through Switch A and Switch B. Configure VLAN mappings on the switches to enable the
hosts on the two customer networks to communicate through public network VLANs.
Switch A provides network access for terminal devices in VLAN 100 and VLAN 200
through GigabitEthernet 1/0/11 and GigabitEthernet 1/0/12. On the other side of the
public network, Switch B provides network access for servers in VLAN 100 and VLAN
200 through GigabitEthernet 1/0/15 and GigabitEthernet 1/0/16.
Switch A provides access to the public network through GigabitEthernet 1/0/10 and
Switch B provides access to the public network through GigabitEthernet 1/0/17.
Configure the switches to have packets of VLAN 100 and packets of VLAN 200 transmitted
in VLAN 500 and VLAN 600 across the public network.
Figure 1-12, two customer networks are connected to the public network
1-47