Console Port Login Configuration With Authentication Mode Being Password; Configuration Procedure - H3C S5100-SI Operation Manual

Network diagram
Configuration PC
running Telnet
Figure 2-6 Network diagram for AUX user interface configuration (with the authentication mode being
none)

Configuration procedure

# Enter system view.
<Sysname> system-view
# Enter AUX user interface view.
[Sysname] user-interface aux 0
# Specify not to authenticate users logging in through the console port.
[Sysname-ui-aux0] authentication-mode none
# Specify commands of level 2 are available to users logging in to the AUX user interface.
[Sysname-ui-aux0] user privilege level 2
# Set the baud rate of the console port to 19,200 bps.
[Sysname-ui-aux0] speed 19200
# Set the maximum number of lines the screen can contain to 30.
[Sysname-ui-aux0] screen-length 30
# Set the maximum number of commands the history command buffer can store to 20.
[Sysname-ui-aux0] history-command max-size 20
# Set the timeout time of the AUX user interface to 6 minutes.
[Sysname-ui-aux0] idle-timeout 6
After the above configuration, you need to modify the configuration of the terminal emulation utility
running on the PC accordingly in the dialog box shown in
Console Port Login Configuration with Authentication Mode Being
Password
Configuration Procedure
Follow these steps to configure console port login with the authentication mode being password:
Ethernet
GE1/0/1
Figure 2-4
2-8
to log in to the switch successfully.