Resetting Dldp State - H3C S5100-SI Operation Manual

Set the DLDP operating mode
Note the following when performing basic DLDP configuration.
DLDP can detect unidirectional links only after the links are connected. Therefore, before enabling
DLDP, make sure that optical fibers or copper twisted pairs are connected.
To ensure unidirectional links can be detected, make sure DLDP is enabled on both sides; and the
interval for sending advertisement packets, authentication mode, and password are the same on
both sides.
The interval for sending advertisement packets ranges from 1 to 100 seconds and defaults to 5
seconds. You can adjust this setting as needed to enable DLDP to respond in time to link failures.
If the interval is too long, STP loops may occur before unidirectional links are terminated; if the
interval is too short, network traffic may increase in vain and available bandwidth decreases.
Normally, the interval is shorter than one-third of the STP convergence time, which is generally 30
seconds.
DLDP does not process any link aggregation control protocol (LACP) event, and treats each link in
the aggregation group as independent.
When connecting two DLDP-enabled devices, make sure the software running on them is of the
same version. Otherwise, DLDP may operate improperly.
When you use the dldp enable/dldp disable command in system view to enable/disable DLDP on
all optical ports of the switch, the configuration takes effect on the existing optical ports, instead of
those added subsequently.
Make sure the authentication mode and password configured on both sides are the same for DLDP
to operate properly.
When DLDP works in enhanced mode, the system can identify two types of unidirectional links:
one is caused by fiber cross-connection and the other is caused by one fiber being not connected
or being disconnected.
When DLDP works in normal mode, the system can identify unidirectional links caused by fiber
cross-connection.
When the device is busy with services and the CPU utilization is high, DLDP may issue mistaken
reports. You are recommended to configure the operating mode of DLDP as manual after
unidirectional links are detected, so as to reduce the influence of mistaken reports.

Resetting DLDP State

You can reset the DLDP state for the ports shut down by DLDP due to unidirectional links to enable
DLDP detection again.
This function is only applicable to ports that are in DLDP down state.
Follow these steps to reset DLDP state:
To do ... Use the command ...
dldp work-mode
{ enhance | normal }
1-9
Remarks
Optional.
By default, DLDP works in
normal mode.