Resetting Dldp State - H3C S5500-EI Series Operation Manual

Operation Manual – DLDP
H3C S5500-EI Series Ethernet Switches
Caution:
To enable DLDP to operate properly, make sure the DLDP authentication modes and
the passwords of the both sides of a link are the same.

1.2.7 Resetting DLDP State

After a unidirectional link is detected, DLDP shuts down the corresponding port. To
enable the port to perform DLDP detect again, you can reset DLDP state for it. A port
can be in different state after you reset DLDP state for it. That is, it can be in Inactive
state (if the port is physically down) or in Active state (if the port is physically up) after
you reset DLDP state for it.
Caution:
The configuration of resetting DLDP state performed in system view applies to all
the ports shut down by DLDP.
The configuration of resetting DLDP state performed in port view or port group view
applies to the current port or all the ports in the port group shut down by DLDP.
I. Resetting DLDP State in System view
Follow these steps to reset DLDP in system view:
To do...
Enter system view
Reset DLDP state
II. Resetting DLDP State in Port view/Port Group View
Follow these steps to reset DLDP state in port view/port group view:
Use the command...
system-view
dldp reset
1-14
Chapter 1 DLDP Configuration
Remarks
—
Required