Wireless Mac Filter - TRENDnet TEW-826DAP User Manual

TRENDnet User's Guide
1. Log into your management page (see
8).
2. Click on Wireless (2.4GHz, 5GHz1, or 5GHz2), and click Wireless RSSI Scanner.
3. Under the Current Profiles list, tick the SSID to enable the RSSI scanner feature.

RSSI Value: First select the minimum RSSI value (client signal strength)
before the AP disconnects the client (-30dBm is better signal strength than
-90dBm).

Tolerance: Then select the tolerance or action once the AP detects the
specified signal strength of the client device is reached.
o
Kick immediately – This setting will immediately disconnect the
client once the specified RSSI value is reached
o
Detect # seconds – Once the specified RSSI value is reached for a
client device, this setting will check the client device signal
strength again after the selected number of seconds. If the signal
strength is still at the specified RSSI value or less, the client will be
disconnected.
4. Click on the Save button then click on the flashing Apply/Discard button
located on the top left section, and click Save & Apply to apply the settings.
Note: Your configurations are not saved and applied until you click on Apply/Discard
Changes button. The Save & Apply step saves and applies all configuration changes.
© Copyright 2018 TRENDnet. All Rights Reserved.
"Access the management page" on page

Wireless MAC filter

Wireless (2.4GHz, 5GHz1, or 5GHz2) > Wireless MAC Filter
Note: Please note that wireless bandwidth control is only available when using AP mode.
Every network device has a unique, 12-digit MAC (Media Access Control) address. Using
wireless MAC filters, you can allow or deny specific wireless clients using this access
point's wireless network.
1. Log into your management page (see
8).
2. Click on the wireless band you would like to configure and click Wireless MAC
Filter.
3. Review the settings and Save then click on the flashing Apply/Discard button
located on the top left section, and click Save & Apply to apply the settings.

Filter Mode: Select from the pull-down list the MAC filter rule to apply.
o
Disable: Select to turn off MAC filter feature
o
DENY: Select this option to DENY all listed MAC addressed
o
ALLOW: Select this option to only ALLOW the listed MAC address
to the network.

MAC Address: Enter the MAC address to apply on the MAC filter rule

MAC: List of all MAC addresses

Delete: Click to remove the selected MAC address from the MAC Filter List
TEW-826DAP
"Access the management page" on page
29