Ospf Cost; Ospf Dr-Priority - HP 6125XLG Command Reference Manual

[Sysname-ospf-1] area 0
[Sysname-ospf-1-area-0.0.0.0] network 192.168.0.0 0.0.255.255
[Sysname] interface vlan-interface 11
[Sysname-Vlan-interface11] ospf bfd enable

ospf cost

Use ospf cost to set an OSPF cost for an interface.
Use undo ospf cost to restore the default.
Syntax
ospf cost value
undo ospf cost
Default
An interface computes its OSPF cost according to the interface bandwidth.
Views
Interface view
Predefined user roles
network-admin
Parameters
value: Specifies an OSPF cost in the range of 0 to 65535 for a loopback interface and in the range of
1 to 65535 for other interfaces.
Usage guidelines
The default OSPF cost is 100 Mbps/Interface bandwidth (Mbps):
• When the cost the interface computes is greater than 65535, the default OSPF cost is 65535.
When the cost the interface computes is less than 1, the default OSPF cost is 1.
•
The ospf cost command sets an OSPF cost for an interface. If you do not use this command, the interface
automatically computes its OSPF cost.
Examples
# Set the OSPF cost on VLAN-interface 10 to 65.
<Sysname> system-view
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] ospf cost 65

ospf dr-priority

Use ospf dr-priority to set the router priority for DR/BDR election on an interface.
Use undo ospf dr-priority to restore the default value.
Syntax
ospf dr-priority priority
undo ospf dr-priority
113