Peer - HP 6125XLG Command Reference Manual

Blade switch layer 3 - ip routing
Table of Contents

Advertisement

Default
The LSA transmission delay is 1 second.
Views
Interface view
Predefined user roles
network-admin
Parameters
seconds: Specifies the LSA transmission delay in the range of 1 to 3600 seconds.
Usage guidelines
Each LSA in the LSDB has an age that is incremented by 1 every second, but the age does not change
during transmission. Adding a transmission delay into the age time is important in low speed networks.
Examples
# Set the LSA transmission delay to 3 seconds on VLAN-interface 10.
<Sysname> system-view
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] ospf trans-delay 3

peer

Use peer to specify a neighbor and a DR priority for the neighbor.
Use undo peer to remove the configuration.
Syntax
peer ip-address [ cost value | dr-priority dr-priority ]
undo peer ip-address
Default
No neighbor is specified.
Views
OSPF view
Predefined user roles
network-admin
Parameters
ip-address: Specifies a neighbor IP address.
cost value: Specifies the cost to reach the neighbor, in the range of 1 to 65535.
dr-priority dr-priority: Specifies the neighbor DR priority, in the range of 0 to 255. The default neighbor
DR priority is 1.
Usage guidelines
On an X.25 or Frame Relay network, you can configure mappings to make the network fully meshed (any
two routers have a direct link in between), so OSPF can handle DR/BDR election as it does on a
broadcast network.
120

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents