Rip Output - HP 6125XLG Command Reference Manual

Blade switch layer 3 - ip routing
Table of Contents

Advertisement

Use undo rip metricout to restore the default.
Syntax
rip metricout [ route-policy route-policy-name ] value
undo rip metricout
Default
The additional metric for outbound routes is 1.
Views
Interface view
Predefined user roles
network-admin
Parameters
route-policy route-policy-name: Uses the specified routing policy to add an additional metric for the
routes matching it. The route-policy-name argument is a case-sensitive string of 1 to 63 characters.
value: Add an additional metric to outbound routes, in the range of 1 to 16.
Usage guidelines
With the command configured on an interface, the metric of RIP routes sent on the interface will be
increased.
If a routing policy is referenced with the route-policy keyword, the following operations can be
performed:
Routes matching the policy is added with the metric specified in the apply cost command
configured in the policy. Routes not matching it are added with the metric specified in the rip
metricout command. The rip metricout command does not support the + or – keyword—used to
add or reduce a metric—specified in the apply cost command.
If the apply cost command is not configured in the policy, all the outbound routes are added with
the metric specified in the rip metricout command.
Examples
# Configure VLAN-interface 10 to add a metric of 6 to the outbound route 1.0.0.0/8 and to add a
metric of 2 to other outbound routes.
<Sysname> system-view
[Sysname] ip prefix-list 123 permit 1.0.0.0 8
[Sysname] route-policy abc permit node 0
[Sysname-route-policy-abc-10] if-match ip address prefix-list 123
[Sysname-route-policy-abc-10] apply cost 6
[Sysname-route-policy-abc-10] quit
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] rip metricin route-policy abc 2
Related commands
apply cost

rip output

Use rip output to enable an interface to send RIP messages.
52

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents