Ospf Cost - HP 5920 Series Command Reference Manual

undo ospf bfd enable
Default
BFD for OSPF is disabled.
Views
Interface view
Predefined user roles
network-admin
Parameters
echo: Enables BFD single-hop echo detection. Without this keyword, this command enables BFD
bidirectional control detection.
Usage guidelines
Do not use OSPF FRR and BFD for OSPF at the same time. Otherwise, OSPF FRR might fail to take effect.
Examples
# Enable BFD for OSPF on VLAN-interface 1 1.
<Sysname> system-view
[Sysname] ospf
[Sysname-ospf-1] area 0
[Sysname-ospf-1-area-0.0.0.0] network 192.168.0.0 0.0.255.255
[Sysname] interface vlan-interface 11
[Sysname-Vlan-interface11] ospf bfd enable

ospf cost

Use ospf cost to set an OSPF cost for an interface.
Use undo ospf cost to restore the default.
Syntax
ospf cost value
undo ospf cost
Default
An interface computes its OSPF cost according to the interface bandwidth.
Views
Interface view
Predefined user roles
network-admin
Parameters
value: Specifies an OSPF cost in the range of 0 to 65535 for a loopback interface and in the range of
1 to 65535 for other interfaces.
Usage guidelines
The ospf cost command sets an OSPF cost for an interface. If you do not use this command, the interface
automatically computes its OSPF cost.
159