Lsa-Generation-Interval - HP 6125XLG Command Reference Manual

Blade switch layer 3 - ip routing
Table of Contents

Advertisement

Usage guidelines
This feature enables the device to output information about neighbor state changes to the configuration
terminal.
Examples
# Disable the logging of neighbor state changes for OSPFv3 process 100.
<Sysname> system-view
[Sysname] ospfv3 100
[Sysname-ospfv3-100] undo log-peer-change

lsa-generation-interval

Use lsa-generation-interval to configure the OSPFv3 LSA generation interval.
Use undo lsa-generation-interval to restore the default.
Syntax
lsa-generation-interval maximum-interval [ minimum-interval [ incremental-interval ] ]
undo lsa-generation-interval
Default
The maximum interval is 5 seconds, the minimum interval is 0 milliseconds, and the incremental interval
is 0 milliseconds.
Views
OSPFv3 view
Predefined user roles
network-admin
Parameters
maximum-interval: Specifies the maximum OSPFv3 LSA generation interval in the range of 1 to 60
seconds.
minimum-interval: Specifies the minimum OSPFv3 LSA generation interval in the range of 10 to 60000
milliseconds. The default is 0, which indicates that the minimum interval can be any value.
incremental-interval: Specifies the OSPFv3 LSA generation incremental interval in the range of 10 to
60000 milliseconds.
Usage guidelines
When network changes are not frequent, LSAs are generated at the minimum-interval. If network
changes become frequent, the LSA generation interval is incremented by incremental-interval × 2
the number of generation times) each time a LSA generation occurs until the maximum-interval is
reached.
The minimum interval and the incremental interval cannot be greater than the maximum interval.
Examples
# Configure the maximum LSA generation interval as 2 seconds, minimum interval as 100 milliseconds,
and incremental interval as 100 milliseconds.
<Sysname> system-view
[Sysname] ospfv3 100
378
n-2
(n is

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents