Network - HP 6125XLG Command Reference Manual

Parameters
number: Specifies the maximum number of ECMP routes.
Usage guidelines
The value range for the number argument and the default setting depend on the max-ecmp-num
command.
If you set the maximum number of ECMP routes to m by using the max-ecmp-num command, the number
argument in the maximum load-balancing command is in the range of 1 to m and defaults to m.
Examples
# Specify the maximum number of ECMP routes as 2.
<Sysname> system-view
[Sysname] rip
[Sysname-rip-1] maximum load-balancing 2
Related commands
max-ecmp-num

network

Use network to enable RIP on an interface attached to a specified network.
Use undo network to disable RIP on an interface attached to a specified network.
Syntax
network network-address
undo network network-address
Default
RIP is disabled on an interface.
Views
RIP view
Predefined user roles
network-admin
Parameters
network-address: Specifies a subnet address where an interface resides.
Usage guidelines
RIP runs only on an interface attached to the specified network. An interface not on the specified network
does not receive or send RIP routes, or advertise its direct routes.
For a single RIP process, the network 0.0.0.0 command can enable RIP on all interfaces. If multiple RIP
processes exist, the command is not applicable.
If a physical interface is attached to multiple networks, you cannot advertise these networks in different
RIP processes.
Examples
# Enable RIP on the interface attached to the network 129.102.0.0.
<Sysname> system-view
44