Lexmark MX310dn User Manual page 187

Troubleshooting
Fax Station Number not set up. Contact system administrator.
Try either of the following:
•
From the printer control panel, select Continue to clear the message. For non‑touch‑screen printer models, press
to confirm.
• Complete the Analog Fax Setup. If the message appears again after completing the setup, then contact your system
support person.
Imaging unit low [84.xy]
You may need to order an imaging unit. If necessary, select Continue on the printer control panel to clear the message
and continue printing. For non‑touch‑screen printer models, press
Imaging unit nearly low [84.xy]
If necessary, select Continue on the printer control panel to clear the message and continue printing. For
non‑touch‑screen printer models, press
Imaging unit very low, [x] estimated pages remain [84.xy]
You may need to replace the imaging unit very soon. For more information, see the "Replacing supplies" section of the
User's Guide.
If necessary, select Continue on the printer control panel to clear the message and continue printing. For
non‑touch‑screen printer models, press
Incorrect paper size, open [paper source] [34]
Try one or more of the following:
•
Load the correct size of paper in the tray.
•
From the printer control panel, select Continue to clear the message and print using a different tray. For
non‑touch‑screen printer models, press
• Check the tray length and width guides and make sure the paper is loaded properly in the tray.
•
Make sure the correct paper size and type are specified in the Printing Preferences or in the Print dialog.
•
Make sure the paper size and type are specified in the Paper menu on the printer control panel.
•
Make sure that the paper size is correctly set. For example, if MP Feeder Size is set to Universal, then make sure
the paper is large enough for the data being printed.
•
Cancel the print job.
to confirm.
to confirm.
to confirm.
to confirm.
187