Lexmark MX310dn User Manual page 119

Understanding the printer menus
Use
Alarms
Alarm Control
Cartridge Alarm
Timeouts
Sleep Mode
Disabled
1–120 min
Timeouts
Timeout
Disabled
1 hour
2 hours
3 hours
6 hours
1 day
2 days
3 days
1 week
2 weeks
1 month
Timeouts
Hibernate Timeout on Connection
Hibernate
Do Not Hibernate
To
Set an alarm to sound when the printer requires user intervention.
When activated, Alarm Control lets you set the number of times
that the alarm sounds, while Cartridge Alarm lets you stop printing
when a cartridge‑low condition occurs.
For each alarm type, select from the following options:
Off
Single
Continuous
Notes:
•
Single is the factory default setting for Alarm Control. This
sounds three quick beeps.
• Off is the factory default setting for Cartridge Alarm. This
means no alarm will sound.
•
Continuous repeats three beeps every 10 seconds.
Set the amount of time the printer waits after a job is printed before
it goes into a reduced power state.
Notes:
• "30 min" is the factory default setting.
•
Disabled appears only when Energy Conserve is set to Off.
•
Lower settings conserve more energy, but may require
longer warm‑up times.
•
Select a high setting if the printer is in constant use. Under
most circumstances, this keeps the printer ready to print
with minimum warm‑up time.
Set the amount of time the printer waits before it goes to Hibernate
mode.
Notes:
•
Disabled is the factory default setting for printers except for
European Union countries and Switzerland.
• "3 days" is the factory default setting for Class B printers in
all European Union countries and Switzerland.
Set the printer to hibernate mode when there is an active Ethernet
connection.
Note: Do Not Hibernate is the factory default setting.
119