Understanding the printer menus
Use
View Security Mode
AppleTalk menu
Note: This menu is available only in printer models connected to a wired network or when an optional network card
is installed.
To access the menu, navigate to any of the following:
•
Network/Ports > Standard Network > Standard Network Setup > AppleTalk
•
Network/Ports > Network Setup [x] > AppleTalk
Use
Activate
Yes
No
View Name
View Address
Set Zone
[list of zones available on the network]
SMTP Setup menu
Use
Primary SMTP Gateway
Primary SMTP Gateway Port
Secondary SMTP Gateway
Secondary SMTP Gateway Port
SMTP Timeout
5–30
Reply Address
To
View the encryption method for the wireless network.
To
Enable or disable AppleTalk support.
Note: Yes is the factory default setting.
Show the assigned AppleTalk name.
Note: The name can be changed only from the Embedded Web Server.
Show the assigned AppleTalk address.
Note: The address can be changed only from the Embedded Web Server.
Provide a list of AppleTalk zones available on the network.
Note: The factory default setting is the default zone for the network. If no
default zone exists, then the zone marked with an asterisk (*) is the default
setting.
To
Specify SMTP server gateway and port information.
Note: 25 is the default SMTP gateway port.
Specify the amount of time in seconds before the server stops trying to
send an e‑mail.
Note: 30 seconds is the factory default setting.
Specify a reply address of up to 128 characters in the e-mail sent by the
printer.
114