Supply Needed To Complete Job - Lexmark MX310dn User Manual

Troubleshooting
Standard USB port disabled [56]
From the printer control panel, select Continue to clear the message. For non‑touch‑screen printer models, press
to confirm.
Notes:
•
The printer discards any data received through the USB port.
•
Make sure the USB Buffer menu is not set to Disabled.

Supply needed to complete job

Do either of the following:
• Install the missing supply to complete the job.
•
Cancel the current job.
Too many flash options installed [58]
1
Turn off the printer.
2
Unplug the power cord from the electrical outlet.
3
Remove the extra flash memory.
4
Connect the power cord to a properly grounded electrical outlet.
5
Turn the printer back on.
Too many trays attached [58]
1
Turn off the printer.
2
Unplug the power cord from the electrical outlet.
3
Remove the extra trays.
4
Connect the power cord to a properly grounded electrical outlet.
5
Turn the printer back on.
Unformatted flash detected [53]
Try one or more of the following:
•
From the printer control, select Continue to stop the defragmentation and continue printing. For non‑touch‑screen
printer models, press
•
Format the flash memory.
Note: If the error message remains, then the flash memory may be defective and need to be replaced.
to confirm.
197