Verifying Printer Setup - Lexmark MX310dn User Manual

Additional printer setup
5
Turn off the printer, and then disconnect the Ethernet cable. Then wait for at least five seconds, and then turn the
printer back on.
6
To verify if your printer is connected to the network, print a network setup page. Then in the Network Card [x]
section, see if the status is Connected.

Verifying printer setup

When all hardware and software options are installed and the printer is turned on, verify that the printer is set up
correctly by printing the following:
•
Menu settings page—Use this page to verify that all printer options are installed correctly. If an option you installed
is not listed, then it is not installed correctly. Remove the option, and then install it again.
•
Network setup page—If your printer has networking support, then use this page to verify that the network
connection is working. This page also provides important information that aids network printing configuration.
Printing a menu settings page
Print a menu settings page to view the current menu settings and to verify if the printer options are installed correctly.
From the printer control panel, navigate to:
> Settings > Reports >
Note: If you have not changed any menu settings, then the menu settings page lists all the factory default settings.
Settings saved from the menus replace the factory default settings as user default settings. A user default setting
remains in effect until you access the menu again, select another value, and save it.
Printing a network setup page
If the printer is attached to a network, then print a network setup page to verify the network connection. This page
also provides important information that aids network printing configuration.
1
From the printer control panel, navigate to:
> Settings > Reports >
Note: If an optional internal print server is installed, then Print Network [x] Setup Page appears.
2
Check the first section of the network setup page, and confirm that the status is Connected.
If the status is Not Connected, then the LAN drop may not be active, or the network cable may be malfunctioning.
Consult your system support person for a solution, and then print another network setup page.
> Menu Settings Page >
> Network Setup Page >
30