Actual load calibration procedures
Calibration procedures vary by the type of calibration. Follow the step number in the table below to
calibrate.
*
When
"C ErrXX"
B: Error Codes}.
Zero calibration only
Span calibration only
Zero and Span calibration
Press [CALF] while pressing [ENTER] in the normal mode, and press [ENTER] next.
1
1
1
"CAL
*
Press [ESC] to return to the normal mode.
Press [ENTER] to get into the zero calibration mode.
Main display:
*
To browse the gross weight, press [SET POINT], it will be displayed on the sub
display. Press [SET POINT] to erase this display.
2
2
*
Press [ESC] to return to the normal mode.
Press [ENTER] at a stable reading (
"-------"
Main display:
*
To end calibration without zero calibrated, press [ESC],
2
To skip zero calibration and perform span calibration only, press [ENTER]. When
"CAL
The displays show;
Main display:
*
The capacity weight is of the value set in CALF-04.
*
To browse the gross weight, press [SET POINT], it will be displayed on the sub
display. Press [SET POINT] to erase this display.
3
3
*
Press [ESC] to return to the normal mode.
*
To end calibration without span calibrated, press [ESC],
Input the weight of the calibration mass using the numerical keys of ([0] - [9]).
Press [ENTER] at a stable reading (
"-------"
Main display:
End Calibration after saving the calibration data in EEPROM.
Press [ENTER] to save the calibration data in the EEPROM and return to the normal
3
4
4
mode.
*
To return to the normal mode without saving the calibration data, press [ESC].
is displayed, there is something wrong with the calibration. See {Appendix
Get in the calibration mode.
Set"
is displayed. (ready to calibrate)
"CAL
0"
/ Sub display:
is displayed for 2 seconds and the displays show;
"CAL
SPn"
Move on to Span calibration.
0"
is displayed, press [F].
"CAL
SPn"
is displayed for 2 seconds and the displays show;
"CAL End"
/ Sub display:
Calibrate Zero.
"
"
"-"
is on beneath "Stable") with no load.
/ Sub display:
"
Capacity weight
Calibrate Span.
/ Sub display:
"
Capacity weight
"-"
is on beneath "Stable").
"
"
4-2
"
"CAL End"
is displayed.
"
"CAL End"
is displayed.