Table of Contents
Advertisement
Commands
*
See {8-6 Data Transmitting Format —Data Format} for "Data Format".
*
See {8-7 Command Mode— Communication procedure} for "Procedure".
Command Command name
RW
(Request Weight)
• The content of the response data is the same as that set with RSF-01.
• Same operation as when the manual print key is pressed.
MZ
(Make Zero)
MT
(Make Tare)
Subtracts the tare. Display shows the net weight.
MN
(Make Net)
MG
(Make Gross)
CT
(Clear Tare)
AM
(Acc.Memory)
CA
(Cancel Acc.)
Subtracts the previous weight/count from the accumulated data.
SSXX
(Set Set points)
• When no code designated (blank), set points now in use are set.
• Set point data length: 7 bytes including polarity.
(Request Set
RSXX
point)
When no code designated (blank), set points now in use are recalled.
CCXX
(Change Code)
BB
(Begin Batch)
• This command is available only in the built-in automatic program mode weighing.
• If used in other weighing mode, "IE" will be transmitted.
(Begin
BD
Discharged)
• This command is available only in the built-in automatic program mode weighing.
• If used in other weighing mode, "IE" will be transmitted.
Function
Recalls the weight
Zero clear
Subtracts the tare
Changes from Gross to Net display
Changes from Net to Gross display
Tare clear
Accumulates weight/count
Cancels accumulation
Sets set points to the code
designated by XX
Recalls set points from the code
designated by XX
Recalls the code number
designated by XX
Begins batch
Begins discharge
8-14
Data
Procedure
Format
B
A/B
A
A
A
A
A
A
A
C
E
B
E
A
A
A
Advertisement
Table of Contents
