AND Explosion Protected Weighing Indicator AD-4403-FP ST Series Instruction Manual page 70

* See {8-6 Data Transmitting Format —Data Format} for "Data Format".
* See {8-7 Command Mode— Communication procedure} for "Procedure".
Command Command name
HB (Halt Batch)
• This command is available only in the built-in automatic program mode weighing.
• In other weighing mode, "IE" will be transmitted.
RF (Request Final)
Outputs the net weight at batch finish.
(Req.Batch
RB
status)
RTXX (Request Total)
• When no code designated (blank), total accumulated weight and the total accumulated count will be
recalled.
DTXX (Delete Total)
When no code designated (blank), total accumulated weight and the total accumulated count will be
deleted.
ET (Erase Total)
Both total accumulated weight and total accumulated count are also cleared.
RE (Read EEPROM)
• The EEPROM stores data related to calibration and functions.
• The data read out with this command can be exported to other Indicator with the "WE" command
• This command is available only when
• Data length: 308 characters, ASCII code (terminators not included.)
WE (Write EEPROM)
This command is available only when
RC (Read Code)
• Set point and accumulation data of the code are read out from the RAM.
• The data of the code number from "0" to "99" and the set point data now in use are output in this
order.
• This command is available only when
WC XX (Write Code)
This command is available only
(Read function
RD
Data)
This command is available only when
(Write function
WD
Data)
This command is available when
Function
Halt batch in an emergency
Recalls the final weight
Recalls the weighing sequence
status
Recalls the accumulated data of
the code designated by XX
Clears the accumulation data of
the code designated by XX
Clears the accumulation data of
all the codes
Recalls the data from the
EEPROM
"CAL SEt"
Writes data (calibration, function)
into the EEPROM
"CAL SEt" is displayed in the calibration mode.
Recalls the data of all the codes
"opErAte"
Write data to the code number
designated by XX
"opErAte" is displayed in the set point editing mode.
Recalls all the function data
"opErAte" is displayed in the set point editing mode.
Write a function data to the
designated code
"opErAte" is displayed in the set point editing mode.
8-15
is displayed in the calibration mode.
is displayed in the set point editing mode.
Data
Procedure
Format
A
B A/B
B H
B C/D
A
A
B
C
B G
C G
D F
C F