Introduction; Features - AND Explosion Protected Weighing Indicator AD-4403-FP ST Series Instruction Manual

St series weighing indicator for explosion protected platform scale

Table of Contents

The AD-4403-FP/ ST is an Explosion protected weighing indicator to be installed and used in

hazardous area: Zone 1 and Zone 2 where explosive gas exists in the air. It complies with the

requirements from IEC (International Electrotechnical Commission) standard: Qualification number:

C13526)

• Complies with "ExdIIBT5X" specifications for explosion protected devices (Qualification number:

C13526 )

• High speed sampling — 100 times per second.

• Five batch weighing modes and four check weighing modes.

• Two control modes;

• Type A: Normal batching/ Loss-in-weigh/ Nozzle controlled weighing mode

• Type B: Check weighing mode.

• Six input and six output terminals for the Control I/O.

• Up to 100 sets of set points are available. Each set is assigned a code number.

• Serial Interface and an buzzer are built in.

• Lithium battery backs up the data of zero compensation, tare weight, set point, and accumulation

data (weight and count).

• Non volatile memory stores the calibration and function setting data.

• Four 350-Ω load cells can be driven.

1. INTRODUCTION

1-1

Table of Contents

Do you have a question about the Explosion Protected Weighing Indicator AD-4403-FP ST Series and is the answer not in the manual?