Weighing Modes - AND Explosion Protected Weighing Indicator AD-4403-FP ST Series Instruction Manual

6-2 Weighing Modes

The indicator-FP has 10 weighing modes, which vary from the weighing method (normal batching or
loss-in weigh) and with/without a PLC (Programmable Logic Controller).
Choose the mode suitable for your weighing at CALF-14. (See {Appendix C: Function List})
Utility PLC.
Normal batching 3)
In use
1)
Loss-in-weigh 4)
Normal
Hopper
batching
scale
3)
Not in
use
2)
Loss-in-weigh 4)
Nozzle Controlled Weighing Mode 5)
Platform
Check
Scale,
In use
Check weighing
1)
weighing 6)
scale
1) PLC in use:
A programmed PLC is required besides the indicator to control the weighing process.
2) PLC not in use:
The built-in program of the indicator controls the weighing process.
3) Normal batching:
Weighs ingredient, controlling the increase in weight by comparing the measured weight with the
set point weight.
4) Loss-in-weigh:
Weighs ingredient, controlling the loss in weight by comparing the measured weight with the set
point weight.
5) Nozzle Controlled Weighing Mode:
Normal batching mode with tare function and nozzle control function.
6) Check weighing:
Weighs ingredient by comparing the measured weight with the target weight, and judges the
result in three ranks, Hi, Go, Lo.
Type of weighing
Without supplementary flow
With supplementary flow
3-stage check weighing
with Over/Under limit
weight-deviation
5-stage check weighing
3-stage check weighing
with Over/Under limit
weight-deviation
5-stage check weighing
Weighing mode
Normal batching
(Customer Programmed Control Mode)
Loss-in-weigh
(Customer Programmed Control Mode)
Normal batching
(Built-in automatic program mode)
Normal batching
(Built-in automatic program mode)
Loss-in-weigh
(Built-in automatic program mode)
Nozzle Controlled Weighing Mode
(Built-in automatic program mode)
Check weighing 1
Check weighing 2
Check weighing 3
Check weighing 4
6-2
Section
6-3
6-4
6-5
6-6
6-7
6-8
6-9
6-10
6-11
6-12