AND Explosion Protected Weighing Indicator AD-4403-FP ST Series Instruction Manual page 111

Section Function
in F: Control I/O—Input
in F-01
in F-02
in F-03
Pin #1 to #9 of control signal terminal
inside the case
in F-04
in F-05
in F-06
outF: Control I/O—Output
outF-01
outF-02
outF-03
Pin #10, 11, 14, 15, 18, and 19 of
control signal terminal inside the case.
outF-04
outF-05
outF-06
SiF: Standard Serial Output
SiF-01
Output data
SiF-02
Data transmitting mode
SiF-03
Baud rate (bps)
SiF-04
Code number output
rSF: OP-03(RS-422/485)OP-04 (RS-232C)
rSF-01
Output data
rSF -02
Data transmitting mode
rSF -03 Baud rate bps
rSF -04
Parity
rSF -05 Character bit length
rSF -06
Stop bit length
rSF -07 Terminator
rSF -08
RS-422/485 switching
rSF -09 Address number
rSF -10
Code number output
Value Section
AnF-01
AnF-02
AnF-03
CALF-01
CALF-02
CALF-03
CALF-04
CALF-05
CALF-06
CALF-07
CALF-08
CALF-09
CALF-10
CALF-11
CALF-12
CALF-13
CALF-14
CALF-15
CALF-16
CALF-17
CALF-18
CALF-19
CALF-20
CALF 21
F-2
Function
AnF: Analog Output
Output data
Weight value at 4 mA output
Weight value at 20 mA output
CALF: Calibration
Weighing unit
Decimal point position
Minimum division
Capacity
Zero range
Zero Tracking Time
Zero Tracking Width
Motion detection time
Motion detection width
Tare and zero compensation at unstable
reading
Tare at negative gross weight
Standard Serial Output: Output When
Weight value Is Overflowing or Unstable.
RS-232C/-422/-485: Output When Weight
value Is Overflowing or Unstable.
Weighing mode
Preset tare
Distinguish between preset tare and tare
Serial interface; Print preset tare value
with net weight (Si F-01=3, rsF-01=3)
Push-zero and tare-clear function when
powered on and when the display is turned
on.
Zero Input Voltage
Span Input Voltage (Capacity to zero)
Weight against Span Input Voltage
Value