Note
*
In the case of built-in-automatic program mode weighing, the set point data is held until batch finish since start of
batching. Therefore, a set point altered during batching takes effect after "batch finish" is output.
*
Chart above is of the case;
• "Acceptable weight" is on.
• A judgement result becomes "Acceptable weight" at the third judgement after supplementary flow action has
been made twice.
*
SqF-26="0":Not tared at batch start
6-15
Need help?
Do you have a question about the Explosion Protected Weighing Indicator AD-4403-FP ST Series and is the answer not in the manual?