AND Explosion Protected Weighing Indicator AD-4403-FP ST Series Instruction Manual page 27

Procedures for each mode
Mode # Name
[0] Mode 0
Press [ENTER] to display the code number with no set point data It
returns to the set point editing mode after the action.
* Press [ESC] to select another mode.
[1] Mode 1
Input a 2-digit code number:
written over.
* Type "0" ahead for a single digit code like "01".
* Press [F] to choose the set point data now in use.
displayed and that means "now in use".
* Press [+/-] to cancel the input and re-input.
* Press [ESC] to return to the set point editing mode.
Press [ENTER] to overwrite the data. It returns to the set point
editing mode after the action.
If the data to be written over ("YY") has a preset set point,
overwriting is not performed.
seconds and the unit a wait to be re-input.
[2] Mode 2
Input the 2-digit code number of the data to be cleared.
* Press [+/-] to cancel the input and re-input.
* Press [ESC] to return to the set point editing mode.
Press [ENTER] to clear the data. It returns to the set point editing
mode after the action.
[3] Mode 3
Input the 2-digit code number of the data to be cleared.
* Press [+/-] to cancel the input and re-input.
* Press [ESC] to return to the set point editing mode.
Press [ENTER] to clear the data. It returns to the set point editing
mode after the action.
Description
Retrieves the code number with no set point data set.
Writes set point data over the set point designated by a
code number.
"XX" to be copied,
"FaiLCoPy"
Clears the set point and accumulation data designated by
a code number.
Clears the accumulation data
3-5
"YY" to be
"--" is
is shown for 2
Display
"CodE bL"
"SEArch "
"SET POINT" LED: ON
"CodE CP"
"XX to YY"
"SET POINT" LED: Blinking
"CodE dt"
"CLEAr "
"SET POINT" LED: Blinking
"CodE tL"
"CLEAr "
"TOTAL" LED: Blinking