AND Explosion Protected Weighing Indicator AD-4403-FP ST Series Instruction Manual page 76

Display
"Chc LEd"
Pressing [F] or [ENTER] shows a relevant number of the LED as
LED.
* To return to the check item-selecting mode, press [ESC].
LED
SET POINT
TOTAL
ACCEPT
OVER
UNDER
"Chc buZ"
Pressing [ENTER] sounds the built-in buzzer and displays
* To return to the check item-selecting mode, press [ESC].
* If the buzzer has sounded continuously for 10 minutes, it returns to the check item-selecting mode
automatically.
"Chc EEP"
Pressing [ENTER] checks the function of the EEPROM and displays
The results of the check will be displayed later.
* The keys will not work while checking the EEPROM.
* To return to the check item-selecting mode, press [ESC].
Result of check
Good condition
Something wrong
"Chc bAt"
Pressing [ENTER] checks the function of the battery. The results of the check will be displayed
later.
Result of check
Good condition
Something wrong
"Chc Si"
Pressing [ENTER] tests the function of the standard serial output by sending
123<CR><LF>(ASCII code) at the baud rate set in the SiF-03 function setting.
displayed for one second and it returns to the check item-selecting mode.
* To return to the check item-selecting mode, press [ESC].
"Chc in"
Displays the status of the control input terminals, #1 to #6, on the control signal terminals, located
inside the case. "□" at an ON terminal is displayed at the lower position, an OFF terminal at the up
position.
* To return to the check item-selecting mode, press [ESC].
Display
"PASS"
"Err"
Display
"PASS"
"Err"
Example: Terminal # 1,3,4,5: ON, and #2, 6: OFF
Check Item
LEDs
Display
"no. 1"
"no. 2"
"no. 3"
"no. 4"
"no. 5"
Buzzer
"buSy"
EEPROM
Lithium battery
Standard serial output
Control input (Terminal #1 to #6)
9-3
"no.XX" and illuminates the
while sounding.
"buSy" while checking.
"Send123" is