PHASER™ 4400 LASER PRINTER Service Manual Warning The following servicing instructions are for use by qualified service personnel only. To avoid personal injury, do not perform any servicing other than that contained in the operating instructions, unless you are qualified to do so.
Caution: A personal injury hazard exists that may not be apparent. For example, a panel may cover the hazardous area. Danger: A personal injury hazard exists in the area where you see the sign. Phaser 4400 Laser Printer Service Manual...
30 minutes. 30 min. Avoid pinching fingers in the printer. Use caution to avoid personal injury. Use caution (or draws attention to a particular component). Refer to the manual(s) for information. Phaser 4400 Laser Printer Service Manual...
If any liquid or foreign material is spilled into the case If the printer is exposed to any excess moisture If the printer is dropped or damaged If you suspect that the product needs servicing or repair Whenever you clean the product Phaser 4400 Laser Printer Service Manual...
Handle ICs and EPROM’s carefully to avoid bending pins. Pay attention to the direction of parts when mounting or inserting them on Printed Circuit Boards (PCB’s). Phaser 4400 Laser Printer Service Manual...
CLASS 1 LASER PRODUCT The Phaser 4400 laser printer is certified to comply with Laser Product Performance Standards set by the U.S. Department of Health and Human Services as a Class 1 Laser Product. This means that this is a class of laser product that does not emit hazardous laser radiation;...
This printer uses heat to fuse the toner image to a sheet of paper. The Fuser Assembly is very hot. Turn the printer power OFF and wait at least 5 minutes for the Fuser to cool before you attempt to service the Fuser Assembly or adjacent components. viii Phaser 4400 Laser Printer Service Manual...
The equipment described in this manual generates and uses radio frequency energy. If it is not installed properly in strict accordance with Xerox instructions, it may cause interference with radio and television reception or may not function properly due to interference from another device.
This product, if used properly in accordance with the user's instructions is neither dangerous for the consumer nor for the environment. A signed copy of the Declaration of Conformity for this product can be obtained from Xerox. Phaser 4400 Laser Printer Service Manual...
Safety Standards Phaser 4400 satisfies the following safety standards: Category Standard Satisfied Laser Safety 100 V/120 V type is submitted to FDA 21 CFR (Chapter 1, Subchapter J, Section 1010/1040). 220 V/240 V type is submitted to IEC 825 Class 1 Laser Product.
Page 12
Phaser 4400 Laser Printer Service Manual...