Xerox 4400DT - Phaser B/W Laser Printer Service Manual page 256

5. Remove the MPT Chute Assembly
6. Remove the Paper Handler Assembly
page 6-57).
7. Remove the Registration Clutch
8. Remove the two E-rings that secure the two Registration Gears as shown.
9. Remove the E-ring from the left end of the Metal Registration Shaft.
10.Release the two registration springs from the Metal Registration Roller. The left
spring is gold-colored, and the right spring silver-colored.
11.Squeeze and hold the Upper Chute and Inlet Chute together. Align the hole in the
chute with the tab on the Left Bearing. Remove the Left Bearing from the Metal
Registration Roller.
Note: Pay attention to the orientation of the Torsion Spring when
removing the Right Bearing.
12.Lift the Torsion Spring and slide the Right Bearing out. Squeeze and hold the
Upper Chute and Inlet Chute together and align the hole in the chute with the tab
on the Right Bearing. Remove the Right Bearing.
13.Slide the Metal Registration Shaft to the right and remove the assembly.
14.Remove the left and right bearings from the Rubber Registration Roller.
15.Lift the right end of the Rubber Registration Roller and remove the roller.
Registration Roller
Phaser 4400 Laser Printer Service Manual
(RRP 4.1 MPT Chute Assembly
(RRP 5.1 Paper Handler Assembly
(RRP 5.5 Registration Clutch
on page 6-44).
on
on page 6-62).
6-63