Xerox 4400DT - Phaser B/W Laser Printer Service Manual page 50

Error Message Summaries (cont'd.)
Note: The messages listed in the "Diagnostic Message" column
appear only in Service Diagnostics while printing Engine
Test Prints. The code numbers in these messages also
appear as part of the Help information displayed when you
press i.
Front Panel Diagnostic
Message Message
Jam at Front; E3-1: Registration
Open Front Jam
Cover to Clear.
Press i.
E3-2: Registration
Jam
Jam At Exit; E4-0: Exit Jam
Open Rear
Cover To Clear.
E4-2: Exit Jam
Press i.
E4-3: Exit Jam
Jam At Stacker; E6-1: Stacker Jam
Open Both Rear
Covers to Clear.
E6-2: Stacker Jam
Press i.
Phaser 4400 Laser Printer Service Manual
Error Description Troubleshooting
Paper Late to Fuser
sensor after arrival at
Registration Sensor.
Exit Sensor did not
actuate within time
after the Registration
clutch is actuated.
1. Registration
Sensor did not
deactuate within time
after actuation of
Registration sensor.
2. Registration
Sensor is actuated at
power-on.
Paper leaves Exit
Sensor early.
1. Paper late off Exit
Sensor.
2. Exit Sensor on at
power-on.
Custom Paper late
off Exit Sensor,
exceeding the
specified time from
Registration Sensor.
1. Paper late to
Stacker Sensor.
1. Paper late off
Stacker Sensor.
2. Stacker Sensor on
at power-on.
Procedure
Open Front Cover.
Remove Print Cartridge.
Clear Paper Path.
Go to Jam at Front; Open
Front Cover to Clear. on
page 2-23.
Open Rear Cover.
Clear Paper Path.
Go to Jam At Exit; Open
Rear Cover To Clear. on
page 2-25.
Open Rear Cover.
Clear Paper Path.
Change Paper Setting in
Custom Mode to correct
size.
Go to Jam At Exit; Open
Rear Cover To Clear. on
page 2-25.
Open Stacker Rear Door.
Clear Paper Path.
Open Printer Rear Cover.
Clear Paper Path.
Go to Jam at Stacker; Open
Both Rear Covers to Clear.
on page 2-27.
2-13