RRP 3.11 Size Sensor Housing
See the Parts List on
Warning: Switch off the power and disconnect the Power Cord.
1.
Remove Tray 1.
2.
Remove the Left Interface Cover
3.
Remove Left Cover
4.
Remove the Front Cover Assembly
page 6-11).
5.
Remove the Left Front Cover Assembly
6.
Remove the Left Plate
7.
Remove the Plate Handle
8.
Disconnect P/J33 from the Engine Logic Board and remove cable from all cable
clamps.
9.
Press the locking pin, slide the housing to the rear of the printer, and remove the
housing.
Size Sensor Housing
6-40
page
7-10.
(RRP 1.1 Left Interface Cover
(RRP 1.2 Left Cover
(RRP 1.11 Left Plate
(RRP 1.12 Plate Handle
on page 6-7).
(RRP 1.6 Front Cover Assembly
(RRP 1.7 Left Front Cover
on page 6-16).
on page 6-17).
Phaser 4400 Laser Printer Service Manual
on page 6-6).
on
on page 6-12).