Voltage Measurements - Xerox 4400DT - Phaser B/W Laser Printer Service Manual

General Notes on Troubleshooting
1. Unless indicated otherwise, the instruction "switch ON printer main power" means
for you to switch ON printer power and let the printer proceed through POST.
2. When instructed to take voltage, continuity or resistance readings on wiring
harness, proceed as follows: check P/J 232–1 to P/J 210–5 by placing the red probe
(+) of your meter on pin 1 of P/J 232, and place the black probe (–) of your meter
on pin 5 of P/J 210.
3. When you are instructed to take voltage readings between "P/J 232
(without specified pin numbers), check all pins. Refer to the section
on page 9-1 for the location of all wiring harnesses and pins.
4. When you are instructed to take a voltage reading, the black probe (–) is generally
connected to a pin that is either RTN (Return) or SG (Signal Ground). You can
substitute any RTN pin or test point in the printer, and you can use FG (frame
ground) in place of any SG pin or test point.
5. Unless a troubleshooting procedure instructs otherwise; before measuring voltages
make sure the printer is switched ON, the Imaging Unit and the paper trays are in
place, and the interlock switches are actuated.
6. All voltage values given in the troubleshooting procedures are approximate values.
The main purpose of voltage readings is to determine whether or not a component
is receiving the correct voltage value from the power supply and if gating (a
voltage drop) occurs during component actuation. Gating signals may be nothing
more than a pulse, resulting in a momentary drop in voltage that may be difficult or
impossible to read on the average multi-meter.
7. When a Troubleshooting Procedure instructs you to replace a non-spared
component and that component is part of a parent assembly, you should replace the
entire parent assembly.

Voltage Measurements

Power and signal grounds are connected to frame ground. You can perform all circuit
troubleshooting using the metal frame (chassis) as the grounding point. If you need
more information to locate connectors or test points, refer to
Unless otherwise specified, the following voltage tolerances are used within this
section.
Voltage Measurements
Stated
+3.3 VDC
+5.0 VDC
2-4
Measured
+3.0 to 3.6 VDC
+4.8 to +5.2 VDC
Stated Measured
+24.0 VDC +21.6 to +26.4 VDC
0.0 VDC Less than +0.5 VDC
Phaser 4400 Laser Printer Service Manual
P/J 210"
Wiring Data
Wiring Data on page 9-1.