Service Diagnostics Resets; Front Panel Shortcut Reset - Xerox 4400DT - Phaser B/W Laser Printer Service Manual

Resetting All Printer Default Settings (PostScript NVRAM)
Resetting the NVRAM restores all printer values stored in the IP controller NVRAM
including network, printer setup, job defaults, and margin to their factory default
values. The print counts and the Adobe firmware serial number are not affected by
this reset.
1. From the Main Menu, scroll to
2. Scroll to
Service Tools Menu
3. Reset NVRAM
4. Highlight
Reset NVRAM
all the settings to their factory default values.
Fuser Reset
The Fuser Reset procedure restarts the counter that tracks Fuser life. The procedure
must be performed following installation of the Maintenance Kit. To perform the
fuser reset:
1. From the Main Menu, scroll to
2. Scroll to
Reset Fuser Life
3. Reset NVRAM
4. Highlight
Reset NVRAM
all the settings to their factory default values.
Select
Menus | Supplies Info Menu | Reset Fuser Life | Reset
Fuser Life NOW

Service Diagnostics Resets

Resetting the NVRAM restores all printer values stored in the Image Processor
controller NVRAM including network, printer setup, job defaults, and margin to their
factory default values.
1. Enter Service Diagnostics.
2. Scroll to
NVRAM Access
3. PostScript NVRAM Reset
4. When "Resetting NVRAM! Are you sure?" is displayed, highlight
OK.
The printer now exits Service Diagnostics and reboots. While booting, NVRAM is
reset.

Front Panel Shortcut Reset

The following front panel shortcut can be used to reset PostScript NVRAM
Mode
Reset PostScript NVRAM
4-8
Support Menu
is highlighted — press OK.
and
Reset Printer NOW
Supplies Info Menu
and press OK.
is highlighted — press OK.
and
Reset Printer NOW
.
and press OK.
is highlighted — press OK.
and press OK.
and press OK.
Press this selection at power-on
BACK+OK
When "Password" appears, press UP +
DOWN keys within 2 seconds.
Phaser 4400 Laser Printer Service Manual
and press OK to reset
and press OK.
and press OK to reset
and press
Yes