The Entire Output Is Blank - Fuji Xerox DocuPrint M355 df User Manual

 The Entire Output Is Blank
Problem

The entire output is blank.

348
Troubleshooting
Action
The toner cartridge may be low or need to be replaced. Confirm the amount of toner
in the toner cartridge.
1 Check the toner level in the Status Monitor window.
2 Replace the toner cartridge as necessary.
If the problem persists, disable Toner Saver in the print driver.
Disable Toner Saver in the print driver. The following procedure uses the PCL 6
driver as an example.
1 On the Image Options tab, ensure that Off is selected in the Toner Saver
drop-down menu.
If the problem persists, try changing the Paper Type setting in the print driver.
The print media surface may be uneven. Try changing the Paper Type setting in the
print driver. For example, change the plain paper to heavyweight using the PCL 6
driver.
1 On the Paper/Output tab, change the Paper Type setting.
If the problem persists, verify that the correct print media is being used.
Verify that the correct print media is being used.
See also:
• "Usable Print Media" on page 125
If not, use the print media recommended for the printer.
If the problem persists, ensure the transfer unit is correctly installed.
Ensure the transfer unit is correctly installed.
See also:
• "Installing a Transfer Unit" on page 393
If the problem persists, replace the drum cartridge if you have a spare cartridge.
Replace the drum cartridge if you have a spare cartridge.
See also:
• "Replacing the Drum Cartridge" on page 385
• "Installing a Drum Cartridge" on page 388
If the problem persists, contact the Fuji Xerox local representative office or an
authorised dealer.