• PS Job Time-Out
Purpose:
To specify the runtime of one PostScript job. The change becomes effective after the printer is turned off and then on
again.
Values:
Off*
On
1min
1-900
• Paper Select Mode
Purpose:
To set the way to select the paper tray for PostScript mode. The change becomes effective after the printer is turned
off and then on again.
Values:
Auto*
Select From Tray
Network Setup
Use the Network Setup menu to change the printer settings affecting jobs sent to the printer through the network.
NOTE:
•
Values marked by an asterisk (*) are the factory default menu settings.
• Ethernet
NOTE:
•
Ethernet feature is available only when the printer is connected using the wired network.
Purpose:
To specify the communication speed and the duplex settings of Ethernet. The change becomes effective after the
printer is turned off and then on again.
Values:
*
Auto
10BASE-T Half
10BASE-T Full
100BASE-TX Half
100BASE-TX Full
1000BASE-T Full
Job time-out does not occur.
A PostScript error occurs if processing is not completed after the specified
time.
The tray is selected as the same setting as in the PCL mode.
The tray is selected in a method compatible with regular PostScript printers.
Detects the Ethernet settings automatically.
Uses 10BASE-T Half-duplex.
Uses 10BASE-T Full-duplex.
Uses 100BASE-TX Half-duplex.
Uses 100BASE-TX Full-duplex.
Uses 1000BASE-T Full-duplex.
Using the Operator Panel Menus and Keypad
261