Clearing Jams; Avoiding Jams - Fuji Xerox DocuPrint M355 df User Manual

Clearing Jams

This section includes:
• "Avoiding Jams" on page 316
• "Identifying the Location of Paper Jams" on page 317
• "Clearing Paper Jams From the DADF" on page 318
• "Clearing Paper Jams From the Bypass Tray" on page 320
• "Clearing Paper Jams From the Standard 250 Sheet Tray" on page 323
• "Clearing Paper Jams From the Fusing Unit" on page 326
• "Clearing Paper Jams From the Duplexer" on page 330
• "Clearing Paper Jams From the Regi Roll" on page 331
• "Clearing Paper Jams From the Optional 250 Sheet Feeder" on page 334
• "Jam Problems" on page 336
Careful selection of appropriate print media and proper loading allow you to avoid most jams.
See also:
• "About Print Media" on page 122
• "Supported Print Media" on page 125
NOTE:
• Before buying large quantities of any print media, it is recommended that you try a sample first.
 Avoiding Jams
• Use only recommended print media.
• See "Loading Print Media in the Standard 250 Sheet Tray and the Optional 250 Sheet Feeder" on page 132
and "Loading Print Media in the Bypass Tray" on page 135
• Do not overload the print media sources. Ensure that the print media stack height does not exceed the
maximum height indicated by the load-line in the tray.
• Do not load wrinkled, creased, damp, or curled print media.
• Flex, fan, and straighten print media before you load it. If a jam occurs with print media, try feeding one sheet at
a time through the bypass tray.
• Do not use print media that you have cut or trimmed.
• Do not mix print media sizes, weights, or types in the same print media source.
• Ensure that the recommended print side is face up when you load the print media.
• Keep print media stored in an acceptable environment.
• Do not remove the feeding tray during a print job.
• Push the tray in firmly after loading.
• Ensure that all cables that connect to the printer are correctly attached.
• Overtightening the guides may cause jams.
• Wipe the feed roller in the tray or bypass tray with a cloth moistened with water if jams caused by misfeeding
paper occur frequently.
See also:
• "About Print Media" on page 122
• "Supported Print Media" on page 125
• "Print Media Storage Guidelines" on page 123
316
Troubleshooting
to load print media properly.