Removing A Routing Destination - Alcatel-Lucent OmniTouch Fax Server Application System Administrator Manual

Removing a routing destination

OmniTouch Fax Server System Administrator Guide - 8AL_90215_USAA ed.01
Here are a few examples of matches, placeholders and their
corresponding formatted results:
DID=5146331493, "$did:xxx xxx-xxxx$" would give "514
633-1439";
DID=5146331493, "$did:xxxx$" would give "1439";
DID=6331493, "$did:xxx xxx-xxxx$" would give " 633-1439";
ANI=6331493, "$ani$" would give "6331439";
ANI=6331493, "$ani:xxxx$" would give "1439";
ANI=6331493, "$ani:\?xxxx$" would give "?1439";
ANI=6331493, "$ani:\\xxxx$" would give "\1439".
OmniTouch Fax Server searches the facsimiletelephonenumber
field until a match is found. The fax is then routed to the user whose
facsimiletelephonenumber field contains the match.
5 In the Mail field, select a notification destination.
Site users are defined in the Users node of the Web Administrator
(see Internal Users on page 13).
Additional notification destinations, such as printers, are originally
defined in the Notification Destinations node of the Web
Administrator (see Notification destinations on page 31).
6 Click OK.
7 Repeat steps 3 through 6 for all required routing destinations.
8 Click OK.
1 In the Web Administrator, select Configuration|Incoming
Routing Table.
2 In the right panel of the Web Administrator, select the checkbox of
the routing rule you would like to modify.
3 Select Remove.
Chapter 3 Web Administrator Site Configuration
45