Installing Third-Party Applications; The Path Selection For Installer Dialog; The Installation Method Dialog - Nikon Scanners Software Reference Manual

Chapter 3
Congratulations! You have successfully installed the Nikon Control software. If
you wish to install the Nikon Scanner plug-in software for use with a third party appli-
cation, please proceed to the next section.

Installing Third-Party Applications

The Path Selection for Installer Dialog

If you are using one of the listed third-party software applications in the
I O
NSTALLER PTIONS
Nikon plug-in software to reside. This is accomplished by entering the destination disk
and path into the P
Nikon Installer will do its best to anticipate where you want the files to go, based on
your host application selection. This path information will automatically appear in the
P text box. If this path is correct, click on C
ATH
path entry, then click on C
If necessary, you can revert to the P
clicking on B .
ACK
Figure 3.13 The P

The Installation Method Dialog

At this time, you need to inform the Nikon Installer whether you will be
installing new host application software and the plug-in onto the destination disk, or
updating an already installed host application and only loading the plug-in onto the des-
tination disk. This is accomplished via the I
Figure 3.14.
Software Reference for Scanners
Software Installation – IBM PC or Compatible
dialog, the Nikon Installer needs to know where you want the
S I
ATH ELECTION FOR NSTALLER
.
ONTINUE
ATH
S
ATH ELECTION FOR
NSTALLATION
dialog, shown in Figure 3.13. The
. If it is incorrect, correct the
ONTINUE
S I
ELECTION FOR NSTALLER
I dialog.
NSTALLER
M dialog, shown in
ETHOD
dialog by
Page 19